Attach The Mounting Plate; Make The Connections - Bosch NWD-455V03-20P Operating Instructions Manual

FlexiDome IP
3.1

Attach the mounting plate

1. Use the mounting plate as a drilling template to drill three
holes in the mounting surface.
2. Use the supplied plugs and screws to attach the mounting
plate to the surface.
3. With a rear connection, leave the cap in place. With a side
connection:
a. remove the cap covering the side entrance;
b. attach a 22 mm / ½ inch (PG16) gland conduit to the
mounting plate.
3.2

Make the connections

To connect the wiring to the camera, use the metal mounting
wire to hold the camera during installation on a ceiling. Make
the power and network connection from inside the connection
box.
Fig. 3.3 Preparation
1. Pull out the connection box from the camera encasing.
2. To open the connection box, loosen the Phillips screws,
and open the cover flips.
CAUTION!
!
Never supply power via the Ethernet connection (PoE) when
power is supplied via the power connector.
Bosch Security Systems
Suspension wire
Connection box
Operating Instructions
Mounting the unit | en 23
V 1.0 | 2006.12