What To Do If You See A Blank Screen; The Projector And Notebook Don't Display The Same Image - Epson PowerLite 7900p User Manual

What To Do If You See a Blank Screen

If you see a blank screen or a blue screen with the
try the following:
Make sure the cables are connected correctly, as described in
■
Chapter 1.
Make sure the P Power light is green and not flashing and the
■
lens cap is off.
If you've connected more than one computer and/or video source,
■
you may need to press one of the
projector's control panel or the remote control to select the
correct source. (Allow a few seconds for the projector to sync up
after pressing the button.)
If you're using a PC notebook, press the function key on your
■
keyboard that lets you display on an external monitor. It may be
labelled
CRT/LCD
to hold down the
Fn
the projector to sync up after changing the setting.
The Projector and Notebook Don't Display the
Same Image
If you're projecting from a notebook, and you can't see your image on
the screen and on your computer at the same time, follow these
guidelines.
If you're using a PC notebook:
■ On most systems, there's a function key that lets you toggle
between the LCD screen and the projector, or display on both at
the same time. It may be labelled
as . You may have to hold down the
it. Allow a few seconds for the projector to sync up after changing
the setting.
■ If the function key doesn't permit you to display simultaneously
on both screens, you should check your monitor settings to make
sure both the LCD screen and the external monitor port are
enabled.
Source
or have an icon such as
key while pressing it. Allow a few seconds for
CRT/LCD
message,
No Signal
buttons on the
. You may have
or with an icon such
key while pressing
Fn
No Signal
Projecting
39