NEC EXPRESS 5800 ES1400 SERIES Online Service Manual page 92

Observe static precautions. Use an antistatic wrist strap.
Remove the device from its protective wrapper and place it on an antistatic surface. Record the
3.
drive model and serial number in the equipment log.
4. Set any drive jumpers or switches before you install the drive. See the documentation that
comes with the device for jumper or switch information.
Note:
already attached.
Slide the drive into the bay until the screw holes line up. It may be necessary to temporarily
5.
loosen the mounting screws on the already installed drives to position the new drive. Secure
the drive to the bay with the four supplied screws.
Power Cable
Connect the signal and power cables to the drive as shown in Figure 5-15. All device power
6.
cables are labeled and must be installed in specific locations as shown below:
7. Replace the front panel and side panels, and power on the system.
4-32 Upgrading Your System
CAUTION
If the drive comes with drive rails, do not use them. Remove any rails
Installing a Removable Media Device
Drive Location
A
B (Tape)
C (CD-ROM)
D (Diskette)
Power Connector
P5
P3
P6
5.25" Drive