Event Description - NEC EXPRESS 5800 ES1400 SERIES Online Service Manual

Using the Sensor Type Code Table
Compare the
Sensor Type/Number in Verbose column in the table below. Using information in the
column in the table you can determine the physical component which generated the SEL
Name
message. The
event to the SEL. Detailed information regarding the event is available from the
column in the SEL Viewer.
For example, if there is a Fan #10 entry in the
by looking at the Sensor type Codes table you can determine that the Baseboard Fan 1 caused this
entry. The entry was reported through the Baseboard Management Controller (BMC) on the
system board.
Sensor Type and Number in Verbose
Reserved
Temperature #17
Temperature #18
Temperature #19
Temperature #1A
Voltage # 01
Voltage # 02
Voltage # 03
Voltage # 04
Voltage # 05
*Not applicable to all servers
Sensor Type and Number
column in the table identifies the microcontroller which reported the
Generator ID
Sensor Type Codes
Sensor Name
00h
Processor1 Temp
Processor2 Temp*
Baseboard Temp1
Baseboard Temp2
Baseboard 5V
Baseboard 3.3V
Primary Processor
Secondary Processor*
Processor 2.5V
message shown in the SEL viewer display (above) to the
Sensor Type and Number
Generator ID
BMC
BMC
BMC
BMC
BMC
BMC
BMC
BMC
BMC
BMC
Emergency Management Port Console C-15
Sensor

Event Description

column of the SEL Viewer,