Removing A 5.25-Inch Device - NEC EXPRESS 5800 ES1400 SERIES Online Service Manual

Removing a 5.25-Inch Device

1. Power off the system and remove the side panels as described earlier in this chapter.
2. Remove the front panel as described earlier in this chapter.
Disconnect the power cable (A) and ribbon data cable (B) from the device you are removing.
3.
4. Remove and save the four screws from the device.
Install an EMI (Electromagnetic Interference) shield and filler panel over the bay from which
5.
you removed the peripheral device.
Replace the side panels and front panel, and power on the system.
6.
Remove the drive serial number from the equipment log.
7.
Removing a Removable Media Device
A
B
Upgrading Your System 4-33