Starting Contact Signal - Hitachi WJ200 Series Instruction Manual

Starting Contact Signal

The inverter gives out the starting contact signal (FR) while it is receiving an
operational command. The FR signal is given out, regardless the setting of the run
command source setting (A002). If the forward operation (FW) and reverse operation
(RV) are given at the same time, the inverter stops the motor operation.
Forward operation command
Reverse operation command
Starting contact signal (FR)
Option Terminal
Code Symbol
Starting contact
41
FR
signal
11, 12, AL0 – AL2
Valid for inputs:
Required settings
Notes:
Function Name State
ON
OFF
Description
Either FW or RV is given, or no operation command
is given
Both FW and RV is given at the same time
Example for terminal [11] (default output
configuration shown – see
Inverter output
terminal circuit
CM2
Example for terminal [AL0], [AL1], [AL2] (requires
output configuration – see
Inverter logic
circuit board
AL0 AL1
Power
supply
See I/O specs on page 4-6
4−77
page 3-90):
FR
11
RY
page 4-52 and 3-90):
FR
AL2
Load