Hitachi WJ200 Series Instruction Manual page 351

B−22
Func.
code
C072 Modbus address
Selection of the operation after
C076
communication error
C077 Communication timeout limit
C078 Communication wait time
C096 Communication selection
C098 EzCOM start adr. of master
C099 EzCOM end adr. of master
C100 EzCOM starting trigger
P140 EzCOM the number of data
P141 EzCOM destination 1 adderss
P142 EzCOM destination 1 register
P143 EzCOM source 1 register
P144 EzCOM destination 2 adderss
P145 EzCOM destination 2 register
P146 EzCOM source 2 register
P147 EzCOM destination 3 adderss
P148 EzCOM destination 3 register
P149 EzCOM source 3 register
P150 EzCOM destination 4 adderss
P151 EzCOM destination 4 register
P152 EzCOM source 4 register
P153 EzCOM destination 5 adderss
P154 EzCOM destination 5 register
P155 EzCOM source 5 register
C001~
Input terminal function
C007
Which parameters to be set?
ALL : Set all inverters in the network.
A : Set admin. inverter (address=1) only.
B : Set all inverters except admin. inverter.
M : Set master inverters configured in C098 to C099 of admin. inverter.
Note 5: Address of Administrative inverter is to be set 01 (C072=01).
Note 6: When selection of operation after communication error is set other than "ignoring errors
(C076=02)", EzCOM function is interrupted in case of communication timeout on administrative inverter.
In this case, please power off/on or reset (on/off RES terminal) to recover.
Note 7:.If EzCOM starting trigger is set as input terminal (C100=00), be sure to configure 81 in one of
input terminals.
Note 8: If EzCOM starting trigger is set as always (C100=01), administrative inverter starts to send the
Name Data/Range For
1 to 247 ALL
00 ALL
ALL
01
02 ALL
ALL
03
ALL
04
0.00 ALL
0.01～99.99 ALL
0.～1000. ALL
00
-
01 B
02 A
01 to 08 A
01 to 08 A
00 A
01 A
1 to 5 M
1 to 247 M
0000 to FFFF M
0000 to FFFF M
1 to 247 M
0000 to FFFF M
0000 to FFFF M
1 to 247 M
0000 to FFFF M
0000 to FFFF M
1 to 247 M
0000 to FFFF M
0000 to FFFF M
1 to 247 M
0000 to FFFF M
0000 to FFFF M
81 A
Description
Network address
tripping
tripping after decelerating
and stopping the motor
ignoring errors
stopping the motor after
free-running
decelerating and stopping
the motor
Disabled
[sec.]
[ms]
Modbus-RTU
EzCOM
EzCOM
< Admin. inverter >
Input terminal (Note 2)
Always
(Note 3)
485: start EzCOM