Panasonic KX-T336 System Reference Manual page 48

4.00 INS (In Service)
Description
Allows you to change the status of shelves, cards
and ports from "Out of Service" to "In Service" in
the following screen, after pressing the COMMON
(Fl) key.
Operation
<Example>
Changing the status of station (physical number
2158) from "Out of Service" to "in Service."
1. Press the F4 key.
n
~4
/CMD >InSeticeNo.=~
2. Enter the physical number of the station "2158."
3. Press the RETLJRN key. RETURN
,'MD > In Service No.=2158 0
""'OK
. U
l l l
* * OK" appears when the station
(physical number: 2158) becomes "ln-
Service."
Conditions
The system should be in on-line communication
mode.
For changing lower device such as station, port
etc.. to "In Service," upper device such as card
and shelf should be In Service beforehand.
The table below shows the devices to be
changed to "In Service" and their Entry numbers.
Elements Entry numbers
Shelf physical number (1 to 3)
Card
physical number (101 to 315) .
Port physical number (1011 to 3158)
Station
extension directory number
(DNxxxx: three or four digits), or
physical number (1011 to 3158)
Attendant
Al, A2 or Port number
(1011
to
Console 3158)
DTMF Receiver
f+=Y
xxx : card physical number
y : 1 for DTMF Receiver 1
2 for DTMF Receiver 2
Conference Trunk Basic conference trunk number
CFBxx (xx : 01 to 08)
Optional conference trunk number
CFOyy(yy:Ol to&I)
If it is impossible to execute the "In Service"
operation, one of the following error messages
appears on the screen.
The error message types depend on the situation.
l
**** ERROR : Illegal parameter
l
**** ERROR : Not installed
l
**** ERROR : Diagnostic failure
l
**** ERROR : Invalid status
For details about the error messages, refer to
Section 9-M "Error Message Tables."
To repeat the "In Service" operation, repeat from
STEP 2.
To return to the COMMON mode, press the
EXIT
(F7) key.
7-J-5