Panasonic KX-T336 System Reference Manual page 607

C. Device Status
1.00 Service Commands and
Their Functions
9.01 INS (In Service) command
Description
At the operation prompt (OPE>), enter INS
command to change the status of the target '
device (shelf, card, station etc.) to 'In Service" in
on-iine communication mode.
Command Format
OPE>INS + Item No. 3
:...
3
(Item)
Device
Input Value
Shelf 1 to 3 (physical number)
Card 1
101
to 315 (physical number)
Port
1011 to 3158 (physical number)
Station DNxxxx (xxxx: extension number;
three or four digits) or Physical
number: four digits
Al-T
Al or A2 or
Physical number: four digits
DTMF Rxxxy (xxx:Card number; y: 1 or 2).
CFBxx or CFOyy (xx: 01 to 08,
yy: 01 to 64)
) .<-
Refer to Section 15-E-3.00 'TST Command
(Test)!' for details about test command.
Conditions
The status of specified devices (shelf, card,
station) should be in "OUS" or "FAULT," and
system must be in on-line mode.
When you change the status of a lower device
(port, station) to "INS," the upper device (shelf,
card) should be in "INS" status.
If you try
to
change the lower device status to
"INS" while upper device is in "OUS" status, the
error message "Invalid Status" appears on the
screen.
When you change
the
status of an upper device
(shelf, card), the status of lower devices (port,
station) change as follows.
Upper device
Lower device
OUS + INS
OUS - INS
Fault e Fault
Upper device
Lower device
Fault --) INS
Fault - INS
ous - ous
Normal operation
When this operation is executed without failure,
initial 'OPEz-" prompt appears again on the
screen.
Operation failed
The error message appears on the screen in the
following cases.
Parameter error
Not installed
Status error
.*
INS failure (Diagnosis error)
15-C-l