Panasonic KX-T336 System Reference Manual page 525

1.02 OUS (Out of Service) Command
Description
Changes the status of the target device
!,srtif.
card, station etc.) to "Out of Service" in ori-ijne
communication mode.
Conditions
The status of target devices (shelf, card, port,
station) should be "INS."
If the system administration terminal is an
Attendant Console (All-), do not change the
status of the following devices from "INS" to
"OUS."
l
Shelf in which ATLC card is installed
l
ATLC card
l
Attendant console assigned as the System
Administration Terminal
During a remote operation, do not changethe
status of the following devices from "INS" to
"OUS."
l
Shelf in which RMT card is installed
l
RMT card (Modem)
Operation
Press the function key OUS.
I
CMD>Out of Service No. = xxxx
Enter the number of the desired device.
Four
input values, see below:
Device Input Value
_ :
Shelf 1 to 3 (physical number)
Card 101 to 315 (physical number)
Port
1011 to 3158 (physical number)
Station DNxxxx (xxxx: extension number;
three or four digits) or Physical
number: four digits
Al-l- Al or A2 or
Physical number: four digits S'C'
DTMF Rxxxy (xxx:Card number; y: 1 or 2)
CNF CFBxx or CFOyy (xx: 01 to 08,
yy:Ol to64)
. .
Refer to Section 14-F 'Functional Test by
Entering Commands" for details about the test
command.
When you change the status
of an upper
device
(shelf, card), the status of .lower devices (port,
station) changes as follows.
Upper device INS - OUS
Lower device INS - OUS
Fault---t Fault
Normal operation
The following message appears on the screen.
l
**** OK
Operation failed
An error message appears on the screen in the
following cases.
l
Parameter error
l
Not installed
l
Status error
14-c-3