Table of Contents
Advertisement
Changing the display low cut On/Off setting.
The following is an example to show how to change the display low cut setting from 2.OFF to
1:ON.
Switch operation
Display example
D4: DSP LOW CUT
D4: DSP LOW CUT
D4: DSP LOW CUT
D4: DSP LOW CUT
D4: DSP LOW CUT
Select D3: 4−20 ALM. OUT from the setting item selection
menu.
The currently set alarm output value used when an alarm
2:OFF
occurs appears.
The cursor appears.
2:OFF
Press
1:ON
The display blinks and the set value is displayed for
confirmation.
Press
1:ON
disappears and the display returns to the condition that the set
value is displayed.
Returns to the menu of setting item selection.
- 86 -
Description
to select 1:ON.
again to write the data. Then the cursor
MENU/ENT
6F8A0917
Advertisement
Table of Contents
