Table of Contents
Advertisement
Changing the pulse width
The following is an example to change the pulse width from 100ms to 250ms.
Switch operation
H3: PLS WIDTH
H3: PLS WIDTH
H3: PLS WIDTH
H3: PLS WIDTH
H3: PLS WIDTH
Note: If you try to set a value exceeding the settable range, *H. OVER SPEC. appears and the value returns to
the previously set value. Try to set a new value again.
Display example
Select H3: PLS WIDTH from the setting item selection menu.
The currently set pulse width appears.
100.0 ms
The cursor appears.
Press
100.0 ms
change.
Change the number of the digit.
200.0 ms
To change other digit, press
↓
the cursor to that digit and change the number there.
250.0 ms
The display blinks and the set value is displayed for
confirmation.
Press
250.0 ms
disappears and the display returns to the condition that the set
value is displayed.
Returns to the menu of setting item selection.
- 97 -
Description
further to move the cursor to the desired digit to
again to write the data. Then the cursor
MENU/ENT
6F8A0917
under this condition to move
Advertisement
Table of Contents
