Checking the count rate and pulse width
How to check the count rate setting is shown below.
To check other setting values, select the following function numbers:
Pulse width mode
Pulse width
Switch operation
H1: COUNT RATE
H1: COUNT RATE
Changing the count rate
The following is an example to change the count rate from 0.01m
Switch operation
H1: COUNT RATE
H1: COUNT RATE
H1: COUNT RATE
H1: COUNT RATE
H1: COUNT RATE
Note: The indicting units for count rate are displayed cyclically as shown below.
3
m
H2: PLS MODE
H3: PLS WIDTH
Display example
Select H1: COUNT RATE from the setting item selection
menu.
1.00000 m3
The currently set count rate appears.
Returns to the menu of setting item selection.
Display example
Select H1: COUNT RATE from the setting item selection
menu.
1.00000 m3
The currently set count rate appears.
The cursor appears.
Press
1.00000 m3
Change the unit to l.
Then press
1000.00 l
and change the number there. Repeat this operation until 200 l
↓
appears on the display.
200.000 l
The display blinks and the set value is displayed for
confirmation.
Press
200.000 l
disappears and the display returns to the condition that the set
value is displayed.
Returns to the menu of setting item selection.
ml
gal
l
- 95 -
Description
3
to 200 l (liter).
Description
further to move the cursor to the digit of unit.
to move the cursor to the desired digit to change
again to write the data. Then the cursor
MENU/ENT
bbl
pt
qt
6F8A0917