Lenovo 10B0 Maintenance Manual page 179

1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 136.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 136
4. Locate the thermal sensor. See "Locating major FRUs and CRUs" on page 78.
5. Pivot the drive bay assembly upward. See "Accessing the system board components and drives" on
page 138.
6. Disconnect the thermal sensor cable from the thermal sensor connector on the system board.
7. On the inner side of the front panel, press the left retaining clip
thermal sensor as shown and then push the clip out of the outer side of the front panel. Then, disengage
the plastic holder holding the thermal sensor from the chassis.
Figure 117. Removing the thermal sensor
8. Pull the entire thermal sensor out of the chassis.
.
Chapter 10 Replacing FRUs (machine types: 10B4, 10B5, 10B6, and 10B7)
1
that secures the plastic holder of the
173