Replacing The Mouse - Lenovo 10B0 Maintenance Manual

2. Connect a new keyboard to the appropriate connector on the computer. Your keyboard might be
connected to a PS/2 keyboard connector
to connect the new keyboard, see "Locating connectors, controls, and indicators on the front of your
computer" on page 76 or "Locating connectors on the rear of your computer" on page 77.
Figure 137. Keyboard connectors

Replacing the mouse

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to replace the mouse.
To replace the mouse, do the following:
1. Remove all media from the drives. Then, turn off all attached devices and the computer.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the old mouse cable from the computer.
4. Connect a new mouse to the appropriate connector on the computer. Your mouse might be connected
to a PS/2 mouse connector
mouse, see "Locating connectors, controls, and indicators on the front of your computer" on page 76 or
"Locating connectors on the rear of your computer" on page 77.
Figure 138. Mouse connectors
1 or a USB connector
1 or a USB connector 2
.
Chapter 10 Replacing FRUs (machine types: 10B4, 10B5, 10B6, and 10B7)
2 . Depending on where you want
. Depending on where you want to connect your
185