Feature Button Programming - Fujitsu CT-10 User Manual

FEATURE BUTTON PROGRAMMING
On each of the CT models and their associated DSS units, the horizontal
rows of buttons can be customized with features to meet each extension
user's particular needs (if allowed by class of service). Buttons that are
registered for
line
or ICM use, however, cannot be assigned a different
feature. Table 4 shows the features and their corresponding feature
number.
To assign a feature to a button, perform the following operation:
1. Lift the handset.
- Listen for dial tone.
2. Dial 5 3.
3. Press the button to be programmed.
- Button lamp lights.
- The feature number (FNO) and feature name are displayed for
the button pressed.
4. If the feature number to be assigned is known, dial the feature
number (FNO) of the selected feature.
-or-
To look up the available FNOs, dial * * *.
- The display shows MXXX (XXX = FNO) #####I (#/##I# = additional
digits to be dialed, if necessary) and the feature name.
- Dial the selected feature number and additional digits if
required.
5. Listen for success tone.
- Button /amp goes off.
6.
Hang up.
147