Nokia ESB26 User Manual page 286

23.
copy running-config startup-config
The copy running-config startup-config command, in Privileged (Enable) mode, saves the
running-configuration as the startup configuration. This is the configuration that will be saved
and loaded each time power to the unit is turned on.
The command is equivalent to the write memory command.
Command Syntax
device-name#copy running-config startup-config
copy running-config download-from
The copy running-config download-from command, in Privileged (Enable) mode, loads a
running-configuration with the specified file name, from a remote server with the specified IP
address.
The commands from the downloaded running-configuration are executed and the result is a
merge between the previous running-configuration and the current switch configuration.
Command Syntax
device-name#copy running-config download-from A.B.C.D CONFIG_FILE
Argument Description
A.B.C.D The IP address of the TFTP server.
CONFIG_FILE The path and name of the source file located on the TFTP server.
Note that the path specification and any file-name limitations may depend on the
software running on the TFTP server.
Example
The following command downloads the running-configuration file named RUN001 located on
C:/ on the TFTP server at IP address 192.192.54.0.
device-name#copy running-config download-from 192.192.54.0 c:/RUN001
copy running-config upload-to
The copy running-config upload-to command, in Privileged (Enable) mode, saves the
running configuration to the specified file on the remote server at the specified IP address.
Command Syntax
device-name#copy running-config upload-to A.B.C.D TARGET_FILE
Argument Description
A.B.C.D The IP address of the TFTP server.
MN700004 Rev 01
Software Upgrade and Reboot Options
275