Nokia ESB26 User Manual page 382

34.
Setting the Traffic Mode
The dot1x control-direction stop-in-traffic command, in Interface Configuration mode, sets
the dot1x traffic mode to Bi-directional Traffic Control. The no form of this command sets
the dot1x traffic mode to "Unidirectional traffic control".
By default, the Bi-directional Traffic Control is enabled.
Command Syntax
device-name(config)#dot1x control-direction stop-in-traffic
device-name(config)#no dot1x control-direction stop-in-traffic
Displaying the 802.1X Information
The table below lists the available 802.1X display commands.
Table 34-6 802.1X Display Commands
C o m m a n d
dot1x
show dot1x
show dot1x radius
show dot1x
interface
show dot1x hosts
Displaying 802.1X Authentication Information
The show dot1x command, in Privileged (Enable) mode, displays information regarding
802.1X authentication.
Command Syntax
device-name#show dot1x
Example
device-name#show dot1x
ReAuthentication
ReAuthentication timer
Unicast-clients compatibility
Radius timeout
Supplicant timeout
Tx-period timeout
Quiet period
=====================================================================
Port Hosts Auth
---------------------------------------------------------------------
MN700004 Rev 01
802.1X Port-Based Authentication
D e s c r i p t i o n
Displays the 802.1X authentication setting globally and on a per-port basis.
Displays information regarding 802.1X authentication.
Displays all RADIUS servers that are configured
Displays the 802.1X for a specific port
Display 802.1X information for all supplicants.
= ENABLED
= 25 sec
= OFF
= 50 sec
= 30 sec
= 5 sec
= 390 sec
UnAuth AuthMethod AuthType
371
ControlDirection