NEC VERSA LXi Service And Reference Manual page 41

Option
CPU Speed Control
Hard Disk Timeout
Video Timeout
Peripheral Timeout
Audio Device
Timeout
Standby Timeout
Auto Suspend
Timeout
LCD Suspend — If enabled, allows you to suspend when the LCD panel is closed or
!
resume when the panel is opened.
Suspend Option — Specifies either Suspend or Save to File (STF) when the LCD
!
Suspend parameter is enabled.
Automatic STF — Enables the system, after 30 minutes in Suspend mode, to save the
!
current working environment to a special file on the hard disk and to power down the
system.
Pressing the
(Windows NT only).
Panel Brightness — Selects the LCD screen brightness.
!
Suspend Warning Tone — Specifies whether the system warning tone sounds when
!
Suspend mode starts. It is best to keep this option enabled.
Remote Power On — Allows the serial port modem or LAN board to wake the system
!
on a ring signal.
Wake Up Alarm/Resume Alarm Time — Allows the alarm to resume the system from
!
Suspend. Designates the time parameter in five minutes increments. (Not applicable in
Windows 2000/98 with ACPI.)
Intel SpeedStep Technology — Selects CPU performance when the system is powered
!
under AC or by battery.
2-20 System Configuration and Setup
Off — Disables power management and all device timeouts. Works well in an
office environment while powering your NEC Versa with AC power.
Custom — Lets you define power management levels and specific device timeouts
according to your own needs and present environment. Custom lets you set the
following timeouts.
Custom Timeout Options
Definition
Sets CPU performance at one of four levels.
Sets the time delay before your hard disk powers
down.
Sets the time delay before your video powers off.
Sets the time delay before your peripherals are
controlled by power management.
Sets the time delay before your audio device powers
off.
Selects the system standby timeout period.
Defines how much time elapses from the time the
system enters Standby mode to the time the system
automatically enters Suspend mode.
key combination also puts the system into Save to File mode
Fn-Power