Disconnecting The Drive - NEC VERSA LXi Service And Reference Manual

With the lever raised, place your fingers on the inside edge of the lever and on each
!
side of the center notch. Pull the drive toward the open side of the battery bay. Do not
apply pressure to the drive surface as you pull.
Once the drive is disconnected, use the lever to lift the drive out of the system. Once
!
removed, only handle the drive by its sides. To avoid damaging the drive, do not hold
the drive by the top and bottom.
Lifting the drive out of the bay
Replace the new drive as follows:
3.
Holding the drive by its sides, pull up the hard drive lever. To avoid damaging the
!
drive, do not hold the drive by the top and bottom.
Keeping the lever raised, lower the new drive into the drive bay.
!

Disconnecting the drive

Disassembly and Reassembly 3-9