Recording (Digital Input); Digital Recording - Kenwood DM-5090 Instruction Manual

Recording (DIGITAL input)

Recording is possible using recordable Mini Discs. When this unit is connected with a component equipped with digital output,
such as a CD player, through a digital cord or optical fiber cable, the signal input through the DIGITAL input jack can be recorded
28
in the digital format (this recording is referred to as digital recording). Enjoy high-quality sound of digital recording!
Preparation
1 Open the write protect tab of the Mini Disc to make it recordable.
2 Load the Mini Disc.
3 Check the remaining recording time.
4 Set the amplifier's input selector to the source to be recorded.

DIGITAL recording

1
Adjust the settings if required.
1 Switch the REC MODE on.
2 Select the setting adjustment mode.
3 Set the selection.
Go to step 2 if setting adjustments are not
required.
2
Select one of "DIGITAL 1, 2 ".
3
Select AUTO or MANUAL.
REC MODE
/CHARA.
JOG DIAL
4 ¢
SET
REC INPUT
AUTO/
MONITOR
MANU.
Each press switches the mode.
1 REC MODE : off
2 REC MODE : on ("AUTO TIME?" displayed.)
The modes are switched by rotating the JOG DIAL.
1 AUTO TIME?
: Setting of the time for detecting a no-sound
blank section during automatic track num-
ber marking.
2 AUTO LEVEL?
: Setting of the level for detecting a non-
sound blank section during automatic track
number marking.
3 REC= WRITING? : Setting of the UTOC writing after recording.
÷ For details on the setting adjustment modes, see "REC MODE key".
Each press switches the mode.
1 ANALOG : Analog "stereo mode"
2 DIGITAL 1 : Optical input mode
3 DIGITAL 2 : Coaxial input mode
4 MONO
: Analog "monaural long-play mode"
Each press switches the mode.
1 goes off (AUTO) : Track numbers are marked automatically.
2 MANUAL
: Track numbers can be marked as desired.
DM-5090 (En)
7
i
¢
£
£