Recording (Digital Input); Digital Recording - Kenwood DM-SE7 Instruction Manual

26

Recording (digital input)

When this unit and CD player are connected with an optical fiber cable, the digital signal input through
the DIGITAL IN (OPTICAL) jack can be recorded in a digital form (this recording is hereinafter referred to
as digital recording). Enjoy high sound quality of digital recording.
Preparation
¶ Load a CD in the CD player.
¶ Open the write protect tab of the Mini Disc to make it recordable.
¶ Load the Mini Disc.
¶ Check the remaining recording time.
¶ Select the CD input on the amplifier.

Digital recording

1
Select the "DIGITAL 1 (or 2)".
REC
INPUT
2
Select "AUTO" or "MANUAL".
AUTO/
MANU.
3
Start recording.
Press twice.
¶
¶
¶ When the EDIT key is pressed during recording, a track
number is inserted in that position.
Recording pause
Recording start
Each press switches the mode.
1 ANALOG
2 DIGITAL 1 : Digital mode (when the system is con-
nected)
3 DIGITAL 2 : (Digital mode spare)
4 MONO
REPEAT SINGLE
0 0 1
Each press switches the mode.
1 goes off (AUTO) : Track numbers are added au-
tomatically.
2 MANUAL
: Track numbers are added
manually.
Extinguished in "AUTO" mode, lit in "MANUAL" mode.
0 0 1
Recording is not possible if the following characters are
displayed.
"UNLOCK" : The sampling frequency is not 32 kHz, 44.1
kHz, 48kHz.
\Use analog recording.
: The optical fiber cable is unplugged or loos-
ened. (The connector is not connected.)
\Connect the optical fiber cable correctly.
"SCMS ON" : Digital recording is prohibited by SCMS.
\Use analog recording.
"Not Audio" : The input digital signal is not an audio
signal.
Also, "DISC FULL", "PROTECTED", "PLAY ONLY".
Recording (digital input)
DM-SE7(En)
9
º
@
"DIGITAL 1 (or 2)" lights up
DIGITAL 1 2
0 : 0 1
L
30 10 5 3 1 0 ( dB)
R
∞
∞
MANUAL
L
( dB)
30 10 5 3 1 0
R
•
¢
@#
•
¢
∞