Operation Of Remote Control Unit - Kenwood DM-SE7 Instruction Manual

16

Operation of remote control unit

Loading batteries
1
Remove the cover.
Operation
The unit can be turned on by plugging the power
cord into a power outlet and pressing the "on/
standby ( )" key of the remote control unit.
After the unit has been turned on, press the desired
operation key.
¶ When pressing more than one remote control keys
successively, press the keys securely by leaving an
interval of 1 second or more between pressing of keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote
sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.
2
Insert batteries.
2
¶ Insert two R6 ("AA"-size) batteries
following the polarity indications.
Remote sensor
6 m
Reference operating range
3
Close the cover.
2
30° 30°
DM-SE7(En)