Introduction; Before Applying Power; Safety Precautions - Kenwood DM-SE7 Instruction Manual

2

Introduction

Before applying power

Units are designed for operation as follows.
U.S.A. and Canada .............................................................................................................................................................. AC 120 V only
Europe and U.K. ................................................................................................................................................................... AC 230 V only
Taiwan ................................................................................................................................................................................... AC 110 V only
For the United Kingdom
1. The mains plug contains a fuse. For replacement, use only a 13- Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in the moulded plug.
3. Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home
or the cable is too short to reach a power point, then obtain an appro priate safety approved extension lead or adapter,
or consult your dealer.If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately,
to avoid a possible shock hazard by inadvertent connection to the mains supply.
IMPORTANT :
The wires in the mains lead are coloured in accordance with the following code :
Blue : Neutral
Brown : Live
Do not connect those leads to the earth terminal of a three - pin plug.

Safety precautions

WARNING :
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The marking is located on the rear panel and says that the
component uses laser beams that have been classified
as Class 1. It means that the unit is utilizing laser beams
that are of a weaker class. There is no danger of hazard-
ous radiation outside the unit.
Caution : Read this section carefully to ensure safe operation.
Factory fitted moulded mains plug
Caution : Read this section carefully to ensure safe operation.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE,
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL
TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED
"DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF
SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTE-
NANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE
APPLIANCE.
REQUIREMENT BY NEDERLAND GAZETTE
Batteries are supplied with this prod-
uct. When they empty, you should not
throw away. Instead, hand them in as
small chemical waste.
Introduction
DM-SE7(En)