Operation Of Remote Control Unit - Kenwood DM-S500 Instruction Manual

Operation of remote control unit

Loading batteries
10
1
Remove the cover.
Operation
The unit can be turned on by plugging the power cord into
a power outlet and pressing the POWER (
remote control unit. After the unit has been turned on, press
the desired operation key.
÷ When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between pressing of keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may
occur. In such a case, change the installation position to avoid malfunction.
2
Insert batteries.
2
÷ Insert two R6 ("AA"-size) batteries following
the polarity indications.
) key of the
6 m
3
Close the cover.
2
Remote sensor
30° 30°
Reference operating range
DM-S500 (En)