System Connections - Kenwood DM-S500 Instruction Manual

System connections

Make connection as shown below. When connecting the
related system components, refer also to the instruction
6
manuals of the related components.
Caution: Do not plug in the power lead until all connections
are completed.
System control cord
Remove the protective cap
before using the DIGITAL IN
jack.
÷ For CD recording, the CD-TEXT function, and for positive system
operation, connect the CD player to "DIGITAL IN OPTICAL 1".
÷ Commercial digital equipment (BS tuner, DAT, etc.) can be connected
to "OPTICAL 2".
Connection to the TAPE 1/MD jacks
The following setup allows to combine this unit with the Series 21
system and control it as a part of a single system.
1
Connect a system control cord to this unit and to one of the
system components connected using other system control
cords (AV Control Center, CD player or cassette deck).
2
Connect an audio cord to the TAPE 1/MD jacks of the AV Control
Center or receiver.
3
Set the input function of the AV Control Center or receiver to
"MD".
÷ Refer to the instruction manual of the AV Control Center or receiver
for details.
To control the system using the GRC-151, GRC-102 or GRC-101
(optional), select "System Control" in the Setup MD menu.
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
Notes Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Audio cord
LINE
DIGITAL IN
REC PLAY
OPTICAL
IN OUT
SYSTEM
CONTROL
L
1 2
R
Optical fiber cable
¢§
(*1)
Malfunction of microprocessor
If operation is not possible or erroneous display appears
even though all connections have been made properly,
reset the microprocessor referring to "In case of diffi-
culty".
AV CONTROL CENTER (sold separately)
or receiver (sold separately)
To SYSTEM CONTROL
terminal
REC OUT
L
R
Digital component (CD player, etc.)
DIGITAL OUTPUT
(OPTICAL)
The above illustration is simply an example.
The actual connected equipment may vary depending on
the sales region.
Connection to the TAPE 2 MONITOR jacks
The system control is not available when the audio cord is con-
nected to the TAPE 2/MONITOR jacks. In this case, do not connect
a system control cord to this unit; otherwise malfunction will
result.
To control this unit using the GRC-151, GRC-102 or GRC-101 (optional),
select "IR" in the Setup MD menu.
@
DM-S500 (En)
PLAY IN
Connect to TAPE 1/MD or
TAPE 2 MONITOR terminal
(*1).
TO WALL AC
OUTLET
o
(*1)
@