Philips FAXJET 325 User Manual page 25

Your fax machine rings once, then there is a moment of
silence and another ring signal after that.
You cannot phone or send faxes.
TRANSM. ERROR, Error report
NO CONNECTION
or REDIAL FAILED
NO LOOP CURRENT
When you lift the receiver of your fax machine you
do not hear the dial tone. The display shows:
NO DIALTONE
BUSY
or fax transmissions are constantly interrupted.
You cannot receive any faxes.
On lifting the handset you hear a tone or silence.
You do not hear the dial tone when using your
cordless telephone.
On lifting the handset of an additional telephone you hear
in the background some brief tones.
You have just noticed how the automatic fax-switch
operates. After the first ring signal the fax machine takes
over the call. When the fax machine has recognised that the
incoming call is a telephone correspondence, the fax
machine will continue to ring.
You have connected your machine to a private
branch exchange, but have not made the proper
setting: Select PABX: YES in function 15.
Try again or send the fax at reduced speed (function 21).
Call your fax partner or try to transmit at a later stage.
Try later or draw your fax partner's attention to a
possible installation fault.
Check the installation of your fax machine.
Check the settings in function 15. Connect your telephone
cable to the socket on the bottom of your fax machine
identified with LINE.
Try to send the fax manually: press l and dial the fax
number. You will hear the call being established. If the
recipient is using an automatic answering device, wait until
you hear a tone after the pre-recorded message. Press
START.
Set the number of ringing signals for the answering
machine or the total number of ringing signals with
function 31 or 32 to lower than five.
You are receiving a fax. At the fax machine: press
START. At an additional telephone: press * and 5.
Replace the handset.
The connection of your cordless phone might be
incorrect. Check whether the cordless phone was
installed correctly and is logged to the base station. For
further instructions refer to the manual of the cordless
phone.
Press * twice to switch off the tones or the outgoing
message. You can now make a call without interfer-
ences (see chapter Easylink).
25