Test Tab - HP xw4600 Service And Technical Reference Manual

Architecture—Displays the workstation bus type and BIOS information. In addition, if the bus is PCI,
information about the PCI configuration is displayed.
Asset Control—Displays the serial number of the computer and also provides processor information.
Communication—Displays information about the computer parallel (LPT) and serial (COM) port
settings, USB, and network controller information.
Graphics—Displays information about the graphics subsystem of the computer.
Input Devices—Displays information about the type of keyboard and mouse.
Memory—Displays information about all memory in the computer, including memory on the board and
any memory modules installed.
Miscellaneous—Displays information obtained from the computers configuration memory (CMOS),
BIOS data area, Interrupt Vector table, and diagnostics component information.
Storage—Displays information about storage media connected to the computer, including all fixed
disks, diskette drives, and optical drives.
System—Displays product type, processor type and speed, coprocessor information, and information
about all ROMs in the computer.

Test tab

The Insight Diagnostics utility provides the capability to test all the major hardware components in the
workstation. You can select from several types of tests:
Quick Test—Provides a predetermined script that samples most hardware components and requires
no user intervention.
Complete Test—Provides a predetermined script during which most hardware components are fully
tested. You can select Interactive or Unattended tests. This changes the devices tested during the
Complete Test. More tests are available in the interactive mode, but these require user intervention.
Custom Test—Provides the most flexibility in controlling the testing of a system. The Custom Test mode
enables you to specifically select which devices, tests, and test parameters to run. You can select tests
that do not require any user interaction through the Interactive and Unattended test modes. More tests
are available in the interactive mode, but these tests require user intervention.
To begin diagnostics testing:
1. Select the Test tab.
2. Select Type of Test to perform, select Test Mode, and then select either Interactive or
Unattended.
3. Choose how you want the test to be executed, either Number of Loops or Total Test Time.
●
When choosing to run the test over a specified number of loops, enter the number of loops to
perform.
●
If you want to run the diagnostic test for a specified time period, enter the amount of time in
minutes.
4. To start the test, select Begin Testing in the lower right corner of the display.
ENWW HP Insight Diagnostics Offline Edition 133