2.
Open the PCI card retention clamp. Press the retention clamp levers down to unsnap, and then
rotate them up (1).
Figure 4-28
3.
If removing a PCI Express x16 graphics card, press in on the release lever (2) while lifting the card
(3) out of the chassis. Store the card in an anti-static bag.
If removing s PCI Express card without a release lever, simply lift the card out of the chassis.
4.
Install a PCI slot cover and close the PCI retention clamp. If the PCI retention clamp levers do not
close, ensure that all cards are properly seated, and then try again.
Installing a PCI Express card
To install a PCI Express card:
1.
Disconnect power from the system
access panel
card support bracket on page
82
Chapter 4 Removal and replacement procedures
Removing a PCI Express card
(Predisassembly procedures on page
(Removing the side access panel on page
80), if installed.
58), remove the side
64), and remove the PCI retainer
(PCI
ENWW