Re Installing The Entry Platen - HP 200 Service Manual

Re installing the Entry Platen

The order in which you replace the screws on the entry platen is important.
1 If the plotter is attached to a support, detach it.
2 Turn the plotter on its back.
3 Reconnect the media sensor to the entry platen (see also page 6 26).
4 Position the entry platen between the two sideplates.
Position the top of the entry platen under all of the small pivots on the inside
of both sideplates, except the back pivot. Rest the entry platen against the back pivot.
Position the bottom of the entry platen above the bottom cover of the plotter.
5 Replace the indicated screw on the
left hand side. (Long dog point screw.)
Tighten this screw, making sure that the
entry platen is aligned tight against the
left sideplate.
Torx-15
LEFT HAND SIDE
C3187 90000
6 Replace the indicated screw on the
right hand side. (Long dog point screw.)
There must be no space between the entry
platen and the left sideplate. It doesn't
matter if there is a small space between
the entry platen and the right sideplate.
1
Torx-15
2
RIGHT HAND SIDE
Removal and Replacement 6 67