When To Calibrate The Plotter; Service Mode - HP 200 Service Manual

When to Calibrate the Plotter

Indications or Repairs Performed
Jagged lines on plots
Cartridges are reseated or replaced
Drive roller is removed or replaced
Media (X-axis) motor is replaced
Configuration-plot X-mark distance is not
500mm ("1mm)
Carriage or carriage LED is removed or replaced
Edge-detect failures occur
Bail failures occur during media loading
Bail sensor is removed or replaced
Bail-lift mechanism is removed or replaced
Media sensor is removed or replaced
Leading and trailing margins of a plot are greater
than 17 mm (0.67 in)
Problems occur scanning a setup sheet.
EEROM is cleared or main PCA is replaced

Service Mode

DnUeS:nN FeSW:Ge ERde
, Switch the plotter off.
. While holding the
Align Cartridges
switch the plotter on.
A Once the LED lights up, release the
Busy
T z z
T z
Di it Ji 220 pl
d
7 2 Calibrations
key down,
Align Cartridges
H z !
d
i b
Draft, Final, Paper
P H H d
Calibration Required
Cartridge Alignment
Cartridge Alignment
Accuracy Calibration
Accuracy Calibration
Accuracy Calibration
Cartridge Alignment
and Setup-Sheet Calibration
Cartridge Alignment
Bail Calibration
Bail Calibration
Bail Calibration
Media-Sensor Calibration
Media-Sensor Calibration
Setup-Sheet Calibration
(In this order:)
1. Bail Calibration
2. Media-Sensor Calibration
3. Cartridge Alignment
4. Accuracy Calibration
5. Setup-Sheet Calibration
Align
Cartridges
key.
H d H H H
H d
Transl/Vellum
z H
H
H
C3187 90000