Removing The Media Sensor - HP 200 Service Manual

Removing the Media Sensor

1 Remove the electronics enclosure
cover D page 6 5.
2 Remove the window D page 6 15.
3 Remove the center cover D page 6 16.
4 Remove the right endcover D page 6 19.
10 If the plotter is mounted on legs, remove
the four screws that attach it to the legs.
SO OLOGOHOGOF
Take care that the plotter does not
fall and injure you.
6 26 Removal and Replacement
5 Disconnect the media sensor cable
connector from the main PCA, and from
the holding clip and ferrite on the right
sideplate.
The ferrite holder opens from the top
Reassembling: The cable goes through the
same ferrite as for the window sensor D page 6 24
6 Place the plotter on a flat surface and
turn it on its back.
It requires two people to lift the plotter
Torx 15
Media-sensor
connector
C3187 90000