Unloading Images To A Computer Using The Dock - HP PhotoSmart 945 User Manual

Unloading Images to a
Computer Using the Dock
1
Confirm the following:
•
The dock insert that came in your camera box is attached to the
top of the camera dock (see the camera dock Setup poster).
•
The USB cable is connected between the camera dock and your
computer, and the power cable is plugged into the dock (see the
camera dock Setup poster)
•
The HP Photo & Imaging software is installed on your computer
(see Installing the Software
•
If you are using a Macintosh computer, the camera's
USB Configuration
USB Configuration
2
Place the camera into the camera dock. The camera will turn
on automatically.
3
Press the Save/Print
Image Unload software will launch on your computer. If you
have set the software to automatically unload the images in
the camera, the images will automatically unload to the
computer. Otherwise, in the
Unload. The images are unloaded to the computer, and then
if there are any still images that were previously selected for
printing (page 60) or selected for
destinations (page 69), those actions are started.
4
When the unload screen on the computer says Finished,
your images have been saved and shared. You can take the
camera out of the dock, or leave it there to recharge the
camera batteries (if the batteries are rechargeable).
132
on page 20).
is set to Disk Drive
on page 88.)
button on the dock. The HP
Welcome
HP Photosmart 945 User's Manual
in the Setup
screen, click
HP Instant Share
menu (see
Start