Using The Pop-Up Flash - HP PhotoSmart 945 User Manual

Using the Pop-up Flash

NOTE
The flash will not work while recording video clips.
The flash is turned off and will not fire
until you manually pop it up by sliding
the pop-up flash
the camera. When the flash is
popped-up, it begins to charge and is
automatically set to the
setting.
To change the flash setting, press the
Flash button on the back of the camera
until the desired setting appears on the
active display. The following table
describes the different flash settings.
NOTE
If you change the flash setting, the
camera will remain in that setting
until you change it or turn off the camera.
Icon Setting
AUTO FLASH
A
AUTO WITH
A
RED-EYE
REDUCTION
FLASH ON
32
release on top of
AUTO FLASH
Description
The camera measures light and uses the
flash if necessary.
The camera measures light and uses the
flash with red-eye reduction if necessary
(see Note below for further description of
red-eye reduction).
The camera always flashes. If the light is
behind your subject, you can use this
setting to increase the light on the front of
your subject. This is called "fill-flash."
HP Photosmart 945 User's Manual
OFF
MF