Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
2 INSTALLING AND CONFIGURING YOUR CANOPY
2 INSTALLING AND CONFIGURING YOUR CANOPY
T1/E1 MULTIPLEXERS
T1/E1 MULTIPLEXERS
2.1
2.1
SAFETY INFORMATION
SAFETY INFORMATION
2.1.1
2.1.1
Compliance
Compliance
It is the responsibility of the installer to be sure that all building and safety codes are met
It is the responsibility of the installer to be sure that all building and safety codes are met
and that the installation is complete and secure.
and that the installation is complete and secure.
For Canadian installations, the entire equipment installation must comply with Canadian
For Canadian installations, the entire equipment installation must comply with Canadian
Standard CSA 22.2, No. 60950, Safety of Information Technology Equipment. For
Standard CSA 22.2, No. 60950, Safety of Information Technology Equipment. For
installations in the United States, the entire equipment installation must be in accordance
installations in the United States, the entire equipment installation must be in accordance
with Article 810 of the United States National Electrical Code.
with Article 810 of the United States National Electrical Code.
2.1.2
2.1.2
Lightning Protection
Lightning Protection
When installed, this equipment is to be connected to a Lightning/Surge Protection Device
When installed, this equipment is to be connected to a Lightning/Surge Protection Device
that meets all applicable national safety requirements.
that meets all applicable national safety requirements.
2.1.3
2.1.3
Electrocution Hazard
Electrocution Hazard
WARNING!
WARNING!
Electrocution Hazard
Electrocution Hazard
This product is intended to be connected to either a 3.3-v DC power source (supplied by
Canopy) or an external −48 v DC supply, which must be electrically isolated from any AC
sources and reliably connected to ground (Protective Earth). Do not install Canopy
products near any type of power line. If any related hardware contacts a power line,
severe bodily harm or death could result!
2.1.4
Power Supply Unit
WARNING!
Substitution of the power supply may impair intrinsic safety. The
Canopy T1/E1 Multiplexer must be used with Model Number TR10R033
manufactured by Cincon Electronics Co., Ltd.
2.2
INSTALLATION PROCEDURES
2.2.1
Package Contents
Verify the contents shipped against the packing list for the box. You should have received
the following:
◦
T1/E1 unit
◦
AC Power supply (Option 1 only)
◦
CD ROM (EMS GUI and the software download application)
Issue 1
T1/E1 Multiplexer Release 3.1
June 2004
26 of 69
Page
Advertisement
Table of Contents
