Initial Configuration Procedures; Installing Software From The Cd-Rom; Figure 14: Rear Panel Option 2: −48 V Dc Polarity; Procedure 5: Installing Software From The Cd-Rom - Motorola Canopy T1 User Manual

Canopy T1/E1 Multiplexer
1. Connect the power cables to the terminal strip ensuring the correct polarity is
maintained.
2. Once the Canopy T1/E1 Multiplexer is mounted in its desired configuration,
connect the supplied terminal strip to the back of the unit. Do this by slowly
pushing the terminal strip into the connector on the back of the Canopy T1/E1
Multiplexer.
3. Connect the power cables to an external −48 v DC supply.
2.3 INITIAL CONFIGURATION PROCEDURES
2.3.1 Installing Software from the CD‐ROM
Follow these steps to install the software that is provided by Motorola Canopy on the CD-
ROM onto your PC.
1. Load software onto your PC.
The T1/E1 Multiplexer EMS Graphical User Interface is provided by Canopy on a
CD-ROM that is shipped with the unit.
2. Install the software from the CD-ROM by double-clicking the setup application or
3. Issue the Start->Run->d:/setup sequence
where d: is the drive letter of your CD-ROM. If you are using a different drive
letter, simply substitute the appropriate drive letter.
Issue 1
Figure 14: Rear panel Option 2: −48 v DC polarity
end of procedure

Procedure 5: Installing Software from the CD-ROM

end of procedure
T1/E1 Multiplexer Release 3.1
June 2004
30 of 69
Page