Ink Cartridge Cover, Inner Media Module Cover - Brother MFC990CW Service Manual

6.1.10 Ink Cartridge Cover, Inner Media Module Cover, Front Cover, and WLAN
PCB (
for WLAN-enabled models)
(1) Lightly lift up the front end of the lower cover and remove the ink cartridge cover by
releasing its cover arm from the lower cover.
(2) On the inside of the front cover, release the retainer and slightly open the cover. Then
release the latches at the right and left ends of the inner media module cover and remove
the cover to the front.
For wireless LAN-enabled models, skip to step (4). For models not supporting wireless
LAN, proceed to step (3).
(3) Lightly lift up the front end of the lower cover and remove the front cover.
Grounding wire *
WLAN PCB harness *
Main PCB
Lower cover
Assembling Note: When mounting the ink cartridge cover, lightly lift up the frond end of
the lower cover, fit the two sockets over the bosses on the lower cover at the angle shown
below and rotate the ink cartridge cover. Then, set the cover arm on the rib on the right side
of the lower cover (see the illustration above).
Lower cover
Main PCB shield
Taptite, cup S
M3x6
*
Front cover
Fit the sockets provided on the ink
cartridge cover over the bosses on
the lower cover.
* For wireless LAN-enabled models
Boss
Boss
Latch
Inner media
module cover
Retainer
110
Cover arm
Ink cartridge cover
6-48
Rib
Latch
Socket
Ink cartridge
cover
(Ink_cartridge_cover)
Cover arm
(6_44)
Confidential