6 ] Check The Control Panel Pcb For Normal Operation (Function Code 13); 7 ] Check The Sensor Operation (Function Code 32); 8 ] Acquire White Level Data And Set Cis Scanner Area (Function Code 55); 9 ] Set An Id Code And Update The Head Property Information - Brother MFC990CW Service Manual

(3) Press the 0, 0, 8, and 6 keys in this order. (For models without numerical keypad, enter 0, 0,
8, and 6 using the
The current base ID code registered appears on the LCD.
ID: XXXXXXXX
(4) If the displayed code is different from the one read in step (1), move the cursor to the digit
to be modified, using the
NOTE: In models with touch panel, if the
software keypad, it is necessary to switch the software keypad between the numerical and
function keypads by pressing the Scan and Copy keys simultaneously.
If the base ID code contains letters "A" through "F," on models with a numerical keypad on
the control panel, press the 1 through 6 keys while holding down the # key, respectively.
On models with a touch panel, press the "A" through "F" keys on the software keypad.
NOTE: To cancel the procedure halfway, press the Stop/Exit key.
(5) Press the OK key (Photo Capture key for models without OK key).
If the registration completes normally, the "COMPLETE" appears on the LCD.
NOTE: If the "FAILED" appears, the registration has failed. Go back to step (2) above.
(6) Wait two seconds for the screen to return to the initial stage of the maintenance mode and
display the "
(7) Press the 9 key twice to return to the standby state. (For models without numerical keypad,
enter 9 twice using the

[ 6 ] Check the control panel PCB for normal operation (Function code 13)

Refer to Chapter 9, Section

[ 7 ] Check the sensor operation (Function code 32)

Refer to Chapter 9, Section

[ 8 ] Acquire white level data and set CIS scanner area (Function code 55)

Refer to Chapter 9, Section

[ 9 ] Set an ID code and update the head property information

Note: Make sure that the Brother Maintenance USB Printer driver has been installed to your
PC. To do it, click Start | Settings | Printers to call up the Printers window and confirm that
the Brother Maintenance USB Printer icon (shown on the sample window on
displayed. If the driver has not been installed, install it referring to
(1) Make sure that your PC is turned off, then connect the machine to your PC using a USB
cable.
(2) Switch your PC on.
(3) On your PC, run the ID/head property utility (brusbsn.exe) in the folder created in
7.1.1. The following window appears.
, and OK keys.)
and keys.
."
, and OK keys.)
9.1.4.7.
9.1.4.9.
9.1.4.17.
7-31
, , , and keys are not displayed on the
Section 7.1.2.
page 7-9) is
Section
Confidential