Brother MFC990CW Service Manual page 390

-- Specify the CIS type --
Note: Before proceeding to the CIS type specification procedure, be sure to update the
firmware to the latest version. Otherwise, an error may occur.
(1) Open the scanner cover and check the CIS type shown on the bar code label.
Press 0 key.
A, C
Press 2 key.
B, D
Press 4 key.
N, P
S, No bar code label
(2) Press the 5 and 9 keys in this order in the initial stage of the maintenance mode. (For
models without numerical keypad, enter 5 and 9 in this order using the
keys.)
The "1:MO 2:CO 3:CHG?" appears on the LCD.
(3) To call up the CIS type menu, press the 3 key. (For models without numerical keypad, enter
3 using the ,
(The "1:MO" is for checking the CIS travel, as described on the previous page. The "2:CO"
is for checking scanning clocks at the factory, so do not access it.)
The "CIS TYPE SET" appears on the LCD.
(4) Check the particular code in the bar code label as specified above.
If the code is "A" or "C," press the 0 key; if "B" or "D," press the 2 key; if "N" or "P," press
the 4 key. The machine returns to the initial stage of the maintenance mode.
If the code is "S" or "No bar code label," first press the 0 key. If the machine returns to the
initial stage of the maintenance mode, the CIS type specification procedure is successfully
completed. If the machine error AF occurs, perform steps (2) and (3) again and press the 4
key. The machine returns to the initial stage of the maintenance mode.
(For models without numerical keypad, enter the corresponding value using the
OK keys.)
Press 0 or 4 key.
and OK keys.)
9-38
Bar code label
(CIS_Label_mini9_E)
, and OK
, and
Confidential