Nec Esmpro Agent - NEC N8800-149F User Manual

5-12 Installing and Using Utilities

NEC ESMPRO Agent

NEC ESMPRO Agent is a utility which acts as an agent (proxy) between NEC Express5800/ft series
and NEC ESMPRO Manager (management PC). For details on the operating environment, the
setting required before the setup, and the installation procedure, see the separate volume "User's
Guide (Setup)."
Device ID in Alert Report
Some NEC Express5800/ft series reports use unique device IDs which correspond to the devices
listed in the table below as the device identification information.
Refer to "Device Path Enumeration" in Chapter 3 "ESX Operation and Configuration" for details.
Supplement
When using NEC ESMPRO Agent, see "NAMES AND FUNCTIONS OF COMPONENTS" in
Chapter 2.
Notice on Operation of NEC ESMPRO Agent
- It may become unable to send report after recovering from hardware failure.
<Workaround>
Execute the following operation after hardware failure recovery.
After replacing the hardware, confirm the status LED 2 on both CPU/IO modules are green
(duplex mode) and log on as a user with root priviledge to execute the following command.
# /opt/nec/esmpro_sa/bin/ESMRestart
* For the status LED position, refer to "NAMES AND FUNCTIONS OF COMPONENTS" of
Chapter 2 "General Description" in User's Guide.
- The following message may be registered on the syslog when starting the system.
"ntagent: libft init failed"
<Workaround>
When ESMftreport/ESMps process does not work, login as a root user and execute ESMRestart.
<Process confirmation procedure>
# ps aux | grep ESM
<ESMRestart executing procedure>
# /opt/nec/esmpro_sa/bin/ESMRestart