Table of Contents
Advertisement
4.
Restart the PCI module.
If the PCI Module 0 was stopped in the step 3, execute the following command and the
PCI module will be started.
# cd /opt/ft/bin
# ./ftsmaint bringup 10
Once the PCI module is started, PCI module diagnosis, mirror volume duplication and
PCI module duplication are performed.
The PCI modules' status LEDs changes as shown below:
[Indications of status LEDs]
Immediately after the PCI module startup until the completion of diagnosis:
LED
1
PRIMARY LED
2
DISK ACCESS LED
LED
3
System FT LED
When duplication of disks is started after the completion of PCI module diagnosis:
LED
1
PRIMARY LED
2
DISK ACCESS LED
LED
3
System FT LED
After the completion of disk duplication and when the PCI modules are duplicated:
LED
1
PRIMARY LED
2
DISK ACCESS LED
LED
3
System FT LED
ESX Operation and Configuration 3-11
Secondary*
-
-
Secondary*
-
Amber or Green blinking
(Green when accessing to HDD)
Secondary*
-
Green
Primary*
Green
Amber or Green blinking
(Green when accessing to HDD)
System
－
Primary*
Green
Amber or Green blinking
(Green when accessing to HDD)
System
－
Primary*
Green
Green
System
Green
Advertisement
Table of Contents
Troubleshooting
