Sharp UX-510A Service Manual page 9

2
Fan the paper, and then tap the edge against a flat surface to even
the stack.
3
Pull the paper release plate toward you and insert the stack of paper
into the tray, print side down.
•
If paper remains in the tray, take it out and combine it into a single
stack with the new paper before adding the new paper.
4
Replace the paper cover on the paper tray.
•
Important: Be sure to replace the paper cover before you put
back the paper release plate down.
Note: If the display shows the following alternating messages when
making a copy or receiving a fax, check the paper tray. If the tray is
empty, add paper and then press the START key. If there is paper,
make sure it is inserted correctly and then press the START key.
SET PAPER &
PRESS START KEY
↑
5
Your fax has been set at the factory to print at normal contrast.
Depending on the type of paper you have loaded, you may find that
you obtain better print quality by changing the setting to LIGHT.
Press these keys:
The display will show: PRINT CONTRAST
Press 1 to select NORMAL or 2 to select LIGHT.
The display will show: COPY CUT-OFF
Press the STOP key to return to the date and time display.
5. Clearing paper jams
If a document doesn't feed properly during transmission or copying, or
DOCUMENT JAMMED appears in the display, first try pressing the
START key. If the document doesn't feed out, open the operation panel
(grasp the front edge at the "PANEL RELEASE" mark and pull up) and
pull it out gently.
1
Press the release marked OPEN and open the print compartment
cover.
•
Caution! The printing head (the strip of metal on the underside of
the frame) applies heat to the imaging film. It may be hot
if a document has just been printed.
1 – 7
UX-510ATH
FO-1470TH
FUNCTION
6
Press twice
NORMAL
LIGHT
1 2
or
STOP