Hard Disk Drive Assembly
Remove the hard disk drive assembly as described below.
1.
Remove the screw (
Place your finger in the center notch of the hard drive lever (
2.
the lever. Be sure that both sides of the lever are raised.
A – Screw
3.
With the lever raised, place your fingers on the inside edge of the lever and
on each side of the center notch. Pull the drive toward the open side of the
battery bay. Do not apply pressure to the drive surface as you pull.
3-12 Disassembly and Reassembly
A
) that secures the hard disk drive.
Hard Disk Drive in the drive bay
B – Hard Disk Drive Lever
Disconnecting the drive
B
C – Hard Disk Drive
) and pull up