1. Turn the main board over so the bottom is facing up.
2. Remove three screws.
3. Lift and disconnect the CPU assembly from the main board. The heat shield
and CPU board comes off as two layered pieces.
Bracket/Insulator Assemblies, Bridge Battery, Power Switch
1. The bridge battery (
2. To remove the Power switch, slide it to the front while at the same time
gently lifting the power switch from the bottom assembly.
3. Remove the Bracket/Insulator assemblies by removing three screws (
lifting the Bracket/Insulator assemblies from the bottom assembly.
A – Bracket/Insulator Assembly Screws
Connector Board, Switch/Cable Cover, Switch/Cable
1. Remove one screw (
2. Lift the switch/cable cover.
3. Disconnect the cable at connector CP8 (
the switch/cable from the two locating pins.
3-28 Disassembly and Reassembly
) is now accessible on the bottom assembly.
B
) to release the switch/cable cover.
A
B
B – Bridge Battery
) on the connector board and lift
A
) and