Windows 95 Systems; Windows Nt Systems - NEC VERSA LX Service And Reference Manual

Windows 95 Systems

In Windows 95, enable the IR port using the IR port setup utility accessible
through the NEC Customize icon. Follow these steps to enable the IR port.
1. Double click the NEC Customize icon.
2. From the display window, select Install IR Setup utility.
3. Click Launch to initiate the IR Setup utility.
The IR Setup utility window displays.
4. Select Enable and click OK.
A message displays indicating that you must reboot your system TWICE to
fully enable the IR port.
5. Click OK to reboot your system. Be sure to reboot your system a second
time before attempting to use the IR port for infrared communication.
6. Click Exit to close the NEC Customize utility window.

Windows NT Systems

In Windows NT, enable the IR port using the hardware BIOS setup utility.
Follow these steps to enable the IR port.
1. Access the BIOS Setup utility at power-on. Just press
similar to the following appears.
Press <F2> to enter Setup
The BIOS Setup main menu appears.
2. Use the down arrow key to select the Peripheral Setup menu.
3. Use the down arrow key to select the IR Serial Port.
4. Use the
sure to check your available resources before making a selection.)
5. Press
ESC
6. Save your settings and exit the BIOS Setup utility.
For the infrared technology to work, you need to follow these guidelines:
T
Position the NEC Versa no more than three feet way from the IR
peripheral device you are using.
T
Make sure there is no greater than a 30° angle between the computer and
the device.
2-32 System Configuration and Setup
keys to change the default value to COM4, IRQ3. (Be
PgUp/PgDn
to return to the BIOS main menu.
when a prompt
F2