Memory Module and Switch Settings
Use the following steps to remove the memory module and access the switch settings.
1.
Close the LCD panel.
2.
Turn over the system and locate the memory module bay.
A – Memory Module Bay Cover
Remove the screw and bay cover.
3.
Locate the SO-DIMM and proceed as follows:
4.
!
Press the locking tabs away from the sides of the SO-DIMM and hold while gently
lifting on the edge of the SO-DIMM.
!
When the edge of the SO-DIMM pops up and is at approximately a 60 degree angle,
pull the SO-DIMM from the socket.
3-4 Disassembly and Reassembly
Locating the memory module bay
B – Screw
Removing an installed SO-DIMM