Pc Programming - Panasonic KX-TAW848 Feature Manual

c)
Second Dial Tone Waiting code
Conditions
• The length of a pause is programmable for each CO line.
• Numbers stored in Memory Dialing can contain pauses.
• When a Second Dial Tone Waiting code is dialed after seizing a CO line, a preprogrammed number of
pauses are inserted after the code.
• ARS
A pause is not automatically inserted between the user-dialed access code and the subsequent digits
when the ARS mode is enabled. (1.1.3 ARS (Automatic Route Selection))
Programming References
PC Programming Manual
2.7.8 [1-1] Slot—LCO Port—Pause Time
2.8.4 [2-3] Timers & Counters—Miscellaneous—During Conversation—Pause Signal Time
2.12.4 [6-4] Second Dial Tone
PT Programming Manual
[416] LCOT Pause Time

1.13.5 PC Programming

Description
Although many PBX features can be programmed using a proprietary telephone (PT) (→ 1.13.15 PT
Programming), a PC connected to the PBX can use the KX-TAW848 Maintenance Console software to
program in further detail. System programming, diagnosis, and data upload/download can be performed
either through on-site programming or remote programming.
1)
On-site Programming: Programming that is performed using an on-site PC connected directly to
the PBX.
2)
Remote Programming: Programming that is performed using an off-site PC that connects to the
PBX via a CO line.
1.
Connection Methods for On-site Programming
Method
Serial Interface
(RS-232C port)
USB
Modem
(connected to SLT
port)*
Description
The PC is connected to the PBX via the Serial Interface
(RS-232C port) of the PBX.
The PC is connected to the PBX via the USB port.
The PC is connected to a modem, which is then connected
to an SLT port of the PBX. Use the modem to dial the
floating extension number (default: 599) assigned to the
analog remote maintenance feature to access the PBX.
1.13 P
Required
Hardware
—
—
RMT card and
user-supplied
modem
Feature Manual 157