Panasonic KX-UDS124 Installation Manual page 19

Connecting an AC Adaptor to a SIP-CS
SIP-CSs comply with the IEEE 802.3af Power-over-Ethernet (PoE) standard. If PoE is available on your
network, these SIP-CSs can receive the necessary power supply from the network through the network cable.
In this case, no AC adaptor is needed for the SIP-CSs.
However, if PoE is not available, you will need to connect an AC adaptor to the SIP-CS.
WARNING
When installing or testing a SIP-CS with an external AC adaptor, the AC adaptor should be plugged
into a wall outlet or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the adaptor may cause it to become disconnected.
Note
Use only the optional AC adaptor KX-A239 for the SIP-CS. For details about the optional AC adaptor, refer
to "AC Adaptor" in "6 Appendix".
1.
Connect the AC adaptor cord to the SIP-CS.
2.
Pass the cord through the groove of the SIP-CS in one of the following three ways.
1 1
To AC Adaptor
KX-A239
3.
Connect the AC adaptor to an AC outlet.
AC Adaptor Cord
2
3 Installing the SIP Cell Stations
3
To AC Adaptor
KX-A239
To AC Adaptor
KX-A239
Installation Guide 19