Panasonic KX-UDS124 Installation Manual page 33

Area
Air synchronisation coverage area
A
(Radius: About 1 m to 40 m)
S-PS coverage area
B
(Radius: About 1 m to 50 m)
Site Survey for Air Synchronisation
After completing site planning, you can use 2 SIP-CSs to conduct the site survey to check radio signal strength.
Then, if necessary, modify the location of the SIP-CSs accordingly. You can check the radio signal strength
by the colour of the SIP-CS's LED.
Confirming the Coverage Area for Air Synchronisation between SIP-CSs
1.
Turn on SIP-CS(1) while holding the RESET switch.
2.
After the LED flashes red, amber and green alternately, release the RESET switch, and then press the
RESET switch again for about 1 second.
When SIP-CS(1) enters Site Survey Master mode, the LED of SIP-CS(1) flashes red and green alternately.
3.
Turn on SIP-CS(2) normally. SIP-CS(2) will enter Site Survey Slave mode automatically when it receives
a signal from SIP-CS(1).
B
A
Description
4 Deployment Procedure
Installation Guide 33