Account Codes - Panasonic DBS576 Section 700 Technical Manual

Chapter 7. SLT Features
To cancel an Absence Message
1. Lift the handset.
2. Enter the Absence Message code (default = 729).
3. Flash the hookswitch.
4. Replace the handset.
Related Programming
• FF1 (System): Extension Class of Service Setting
• FF3 (Extension): Extension Class of Service Assignment
• FF8 (Maintenance): Absence Messages
Considerations
• Calling parties without a display get a busy signal, rather than the Absence Message.
• Regardless of setting an Absence Message on a DID/DIL extension, DID/DIL calls are routed
according to the trunk ringing setting.
• An absence message may also be cancelled by dialing 7**. This cancels Do Not Disturb and Call
Forwarding-All Calls as well.

Account Codes

CPC-96, CPC-288, and CPC-576 All Versions
Description
You can assign account codes to clients to facilitate billing and to track call dates and times, numbers
called, and outside line numbers used. This information is printed for each account on the System
Message Detail Recording (SMDR) record.
In addition verified account codes may be used to change the TRS level to allow calls to numbers
otherwise restricted.
Account codes may be either forced or unforced (voluntary) and either verified or unverified.
This feature works with Station Message Detail Recording (SMDR). Before making an outgoing call,
a station user can silently enter an accounting or client billing code. Then later, the SMDR reports will
show the Code dialed for each call, and even sort the report by these Codes.
There are two different types of account codes you can use in the DBS 576:
Non-Verified Account Codes
Non-Verified Codes aren't checked by the system for validity; the user can enter anything from 1-10
digits long. Individual phones can be programmed to accept forced Account Codes (the user must
enter a code for every call) or voluntary Account Codes (the user can enter a code, but doesn't have
to, for each call).
Non-Verified Account Codes can be assigned to outgoing calls. The user either enters the Code before
accessing an outside line (for forced or voluntary Codes).
270
Action
DBS 576 (USA), issued January 1999
Section 700 - Operation
Result
Intercom dial tone
576-20-700